Effects of nanoparticles on Daphnia magna population dynamics

Spherical TiO₂ nanoparticles (npTiO₂) were prepared by controlled hydrolysis of tetraethoxy orthotitanate under a nitrogen atmosphere. ZnO nanoparticles (npZnO) were prepared using hydrothermal methods. The crystal structure, chemical, thermal and morphological properties of npZnO and npTiO₂ were characterised using Fourier Transform Infrared Spectrometer, enery-dispersive X-ray spectroscopy, X-ray diffraction, and scanning electron microscope techniques. The short- and long-term experiments were started with neonates taken from the same culture and laboratory condition. In the acute experiments, npTiO₂, npZnO, and cocktail concentrations were applied. 96h-LC₅₀ values were 1.8, 0.7, and 0.1?mg?L^?1, respectively (p?<?.05). For the chronic experiments, different npTiO₂ concentrations were performed. 21d-LC₅₀ value was 1.0?mgL^?1 (p?<?.05). Morphometry became progressively worse in concentrations of more than 1?mgL^?1 npTiO₂. Neonate and young individuals were more sensitive to death because of their low tolerance. This result was affected by population progeny and growth rates (p?<?.05). While control and 0.5?mgL^?1 npTiO₂ groups were determined as growing population, 1.5 and 2?mgL^?1 npTiO₂ groups had decreased population size as R₀ values. Consequently, the relationships between nanoparticle accumulation within Daphnia magna and its population structure and body morphometry for each concentration were important indicators. Its tolerance level to nanoparticles under laboratory conditions reflected its replacement and behaviour in the ecosystem.     

Highly active mixed-phase TiO2 photocatalysts fabricated at low temperature and the correlation between phase composition and photocatalytic activity

The idea of varying volume ratio of water to ethanol in solvent was firstly employed to yield phase composition controllable mixedphase titanium dioxide (TiO2) photocatalysts via a low temperature solvothermal route at 353 K. It was found that anatase contents increase from 0 to 100% with increase of ethanol contents in solvent. The mixed-phase TiO2 with 60% anatase content exhibited the best photocatalytic activity in photodecomposing formaldehyde (FAD) under UV light irradiation, which increases by about ...     

超高压深海环境下多结构并行疲劳试验技术研究

针对全海深载人潜水器2只载人舱缩比球壳模型的疲劳试验,通过理论方法对比分析了压差法与外压单独作用下球壳的应力状态,验证了超高压深海环境下内外压差法模拟球壳作业环境的可行性。同时,为降低球壳外部交变载荷对试验设备的损伤,并有效缩短试验时长,提出一种计及超高压深海环境下采用内外压差法开展的多结构并行疲劳试验技术。根据该试验技术进行了近7 000个循环周期的双球串联疲劳试验,有力地保证了全海深载人潜水器的研制周期。试验结果表明,该试验技术长期有效可靠,可为同类型试验提供技术依据和应用参考。     

Ag/TiO2光电催化降解染料及出水有机质影响机制

本研究以阳极氧化法结合电化学沉积法成功制备的具有高度整齐有序纳米管结构的Ag/TiO₂纳米管阵列（Ag/TNTAs）为阳极,碳/聚四氟乙烯为阴极构建光电催化（PEC）体系.并探究其光电催化降解甲基橙（MO）效能,结果表明,Ag/TNTAs光电催化降解能力（68.2%）远高于光催化（18.9%）、电化学氧化（38.2%）和直接光解;另外在水质净化厂出水有机质（EfOM）参与的光电体系中,当EfOM的初始浓度小于或等于1.0mgC/L时,其对光电催化降解MO起到促进作用,其中当其浓度为0.4mgC/L时促进作用最为明显.而高浓度的EfOM则抑制光电催化活性.此研究表明光电催化体系能高效催化染料降解,且EfOM能在一定阈值范围内促进光电催化降解污染物.     

TiO2介孔球的合成及其对双酚A的光催化降解

以不同的含钛化合物作为原料,在无模板条件下经一步溶剂热法合成了两种TiO2介孔球——TiO2-1和TiO2-2。对两种TiO2介孔球的形貌进行了表征,结果表明:TiO2-1和TiO2-2粒径分别为5.7 nm和8.0 nm;比表面积分别为159.4 m2/g和128.3 m2/g;孔径约为4.0 nm和5.0 nm。采用P25型TiO2、TiO2-1和TiO2-2对双酚A溶液进行光催化降解反应。在催化剂加入量为0.5 mg/L的条件下降解60 min,双酚A去除率分别为76.3%,99.7%,98.5%。TiO2-1和TiO2-2的光催化效果优于P25型TiO2,且TiO2-1的光催化效果更好。     

苯酚水溶液光催化降解的盐效应

实验研究了不同浓度的NaCl, KCl, KBr, CaCl₂和Na₂SO₄等电解质对323K下苯酚水溶液光催化降解速度的影响,采用分光光度法测定了光催化降解的动力学曲线.结果表明,各种电解质对苯酚的光催化降解均有抑制作用,且随电解质浓度的增加而增强;盐效应强弱主要取决于阴离子而不是阳离子;对于所研究的体系,阴离子的盐效应作用顺序为Br->SO₄^2->Cl^-.光催化过程的盐效应可能与阴离子对光催化剂表面光生空穴的俘获和稳定作用以及阳离子的电导作用引起催化剂表面光生电子和空穴之间的短路有关.     

钛白废酸固液分离与综合利用

介绍了湖南株洲化工集团有限责任公司钛白废酸固液分离与综合利用工艺。将钛白废酸固液分离后得到的清废酸用作磷肥生产用硫酸稀释液、钛白酸解工序硫酸稀释液和板框浸取液,取得了较好的经济效益和环境效益。     

不同波段紫外光在TiO2悬浊液中的消光特点

为确定TiO₂催化剂悬浊液对不同波段紫外光的消光规律,本试验以4-CBA-Na为模型污染物,针对催化剂/污染物悬浊液体系在不同催化剂投加量下,对UVA、UVB和UVC波段光子的消光效果进行了测定.结果表明,各悬浮体系对各波段紫外光的消光基本上符合比耳定律,即随着入射光程的增加,光强呈现负指数衰减;紫外光在催化剂悬浊液中的消光系数随催化剂投加量的增大而增加,其增加规律可以用二次多项式表示;污染物溶液本身对UVB和UVC紫外光有吸收,UVB和UVC紫外光在催化剂-污染物悬浮体系中的消光系数可视为污染物与催化剂颗粒的消光系数之叠加.催化剂悬浊液对紫外光的消光系数随紫外光波长的减小而增大,这意味着使用短波长的UVC作为光催化降解光源可以提高能量利用效率.     

深度氧化技术处理有机废水的研究进展

利用深度氧化技术处理有机废水是目前国内外废水处理的新技术,在美国和欧洲等发达国家,该技术已应用于各种废水和饮用水处理过程。针对我国石油、石化企业在外排废水中所含有毒有害有机物质大多难以降解的特点,经过调研,详细介绍了深度氧化技术处理有机废水的研究进展,并着重探讨了在光催化氧化技术、超声降解技术、超临界水氧化技术、湿式氧化技术等方面所做的工作及深度氧化过程除去水中有机污染物的原理。     

RuO2/La2O3/TiO2悬浮体系中直接耐晒黑G的光催化降解

钛酸丁酯为前驱体,采用溶胶-凝胶-浸渍法制备RuO2/La2O3/TiO2复合光催化剂,以紫外灯为光源,研究了催化剂组成、煅烧温度、溶液pH值等因素对直接耐晒黑G(DFBG)光催化降解的影响.结果表明掺杂量w(La2O3)1.39%、w(RuO2)0.12%、煅烧温度500℃(2 h)、溶液pH值7.3时,光催化活性最佳.当通气量为200 mL/min,催化剂投加量为150mg时,50 mg/L的DFBG溶液经60 min降解,其降解率近100%.DFBG的光催化降解服从Langmuir-Hinshelwood动力学模型,测得相应的动力学参数k=7.42×10-3mmol/L·min,K=19.54 L/mmol.